Blade Network Technologies RACKSWITCH G8124 Guía de instalación descargar pdf (Pagina 37)

RackSwitch G8124 Installation Guide

BPP-00018-01, December 2009 Chapter 2: Installing the RackSwitch G8124

 37

SFP Copper Transceiver

The SFP copper transceiver provides an RJ-45 connector that accepts a standard

10/100/1000Base-T (category 5) cable.

Perform the following steps to install an SFP copper transceiver into a 1Gbps SFP slot on the G8124

switch unit.

Note – To avoid damage to the cable or the SFP transceiver, do not connect the cable before you

install the transceiver.

1. Remove the safety cap and pull the locking lever into the down (unlocked) position.

2. Insert the transceiver into the port until it clicks into place. Use minimal pressure

when you insert the transceiver into the slot. Do not use excessive force when you insert the

transceiver; you can damage the transceiver or the SFP slot.

The transceiver has a mechanical guide key to prevent you from inserting the

transceiver incorrectly.

3. Pull up the locking lever to lock the transceiver into place.

4. Connect the cable.

To remove a SFP copper transceiver, disconnect the cable, and pull down the locking lever to

release the transceiver. After you remove the transceiver, replace the safety cap.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Sin comentarios

Blade Network Technologies RACKSWITCH G8124 Guía de instalación Pagina 37